What Are The Dismantling And Assembling Methods of The Tire Changer
The methods for disassembling tire changers can be categorized into two main types: the methods for flat-bottom rim tires and the methods for deep-set tires. Below is a detailed guide on how to disassemble and assemble flat-bottom rim tires, including their installation procedures. I hope this information is useful to you.
Here is the content list:
– Method for disassembling flat rim tires
– Method for mounting flat rim tires
Method for disassembling flat rim tires
Flat-rim tires are attached to the rim using a pressure ring and a strip. Consequently, the tire can be easily removed from the rim once the strip is taken off. To start, place the tire to be dismantled on the tire changer’s moving pallet, ensuring the side with the strip is facing outward. Secure the tire onto the gripper using the aforementioned technique, raise the tire to the working height, and completely deflate it. Adjust the disassembly position and use the disassembly disc on both sides of the tire (apply brush grease to the tire side, tire mouth, and rim with a brush) to loosen the tire mouth, pressure ring, and strip. Stop the tire’s rotation by prying up the opening of the clamping bar by hand. This allows the disassembly disc along the top of the prying bar to rotate the clamping claw, causing the tire to rotate, and the clamping bar can then be removed. This step requires extra caution to prevent the strip from popping out suddenly. Halt the tire rotation, remove the pressure ring, push the inner tube valve nozzle to the rim groove, and then move the disassembly rod to the left working card slot. Adjust the height and distance, use the disc to extrude the tire rim, and completely remove the tire.
Method for mounting flat rim tires
To install a tire on a flat rim, place the tire inside the tire changer and fill it with air. Secure the rim on the clamping claw as described earlier, place the tire on the movable pallet, adjust the height of the clamping claw (rim), and move the pallet closer. Install the valve nozzle into the mouth slot of the rim, then move the pallet to set the tire into the rim, position the pressure ring and the clamping strip, and roll the clamping strip onto the rim with the disassembly disc. Ensure that the pressure strip or pressure ring is completely lodged into the rim groove. Lower the tire onto the trawl, release the claw, move the trawl outwards, and push the tire down. The tire loading process is complete.
The procedure for disassembling and installing deep-set tires is similar and can follow the same steps.
Yantai Sunmo Electronic Equipment Co., Ltd. specializes in manufacturing tire changers. With a team of professionals, you might consider purchasing our company’s products.
